Hi. I have a problem: I can't open CUCM sdl files after few hours the maximum is 1-2 hour, I think they are getting overwritten by new sdl files... Also same thing with alerts-few hours and nothing.
Is it disk space problem or some setting on CUCM ?
If yes How to change that space ? where are those settings?
can you check the values for logpartitionlowwatermarkexceeded and logPartitionHighWaterMarkexceeded
1. Open RTMT tool using the IP address of the publisher. Inside RTMT click on 'Alert Central'
2. Then select 'LogPartitionLowWaterMarkexceeded' Right click and select 'Set Alert/Properties' >> click on next.
4. Note the current value of logpartitionlowwatermarkexceeded
5. Repeat the previous steps for LogPartitionHighWaterMarkexceeded
you can increase these values to 80 and 90 respectively and compare the results.