cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2979
Views
0
Helpful
3
Replies

CUCM SIP Trunk issues

Kosi227
Level 1
Level 1

Hi all,

 

we received a problem from a customer about their CUBE SIP , the customer can use the sip for out going call and it was working fine, but when people trying to call to their ip phone from outside, the phone will ring, when he pick up will no audio and got fast busy tone. 

we try to change the early offer setting and mtp in CUCM , but same result.

we capture the ccsip message and found that , that CUBE keep sending invite message to CUCM, but the CUCM doesn't  reply acknowledge message. any one know why would this happened ?

 

i attached the setting and debug in here and please help 

 

connection diagram:

CUCM -> sip trunk --> cube -->SIP --> ITSP

 

IP PHONE --> make call --> SIP   success

outside call to ITSP -->SIP -->CUBE--> CUCM   ip phone will ring but fail to pickup

 

Thanks

 

 

 

Accept what was and what is, and you’ll have more positive energy to pursue what will be.
3 Replies 3

Please take a packet capture from CUCM side and confirm that CUCM actually received these SIP messages.

finally we found out the root cause is the ASA block the RTP signal by SIP inspecting setting,

and the problem solved after enable it

 

thanks all !

Accept what was and what is, and you’ll have more positive energy to pursue what will be.

jonathan.salter
Level 3
Level 3
Sounds like a media resource/codec mismatch issue. What are the region settings in CUCM?
Please remember to rate useful posts, click on the stars below.
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: