07-26-2011 07:48 AM - edited 03-16-2019 06:07 AM
I have CUCM 7.1.5 and i have an adtran 850. i have connected the 850 via T1 CAS connection to a 2811 running mgcp.
I get calls inbound and out just fine. The only problem i have is that the calls show a call ID of unknown.
Is there a way to add an extention number to the port?
Solved! Go to Solution.
07-26-2011 08:52 AM
07-26-2011 08:52 AM
Hi
are these checked under the port
07-26-2011 09:12 AM
Thats on a PRI connection, this is a CAS so the ports are EandM
07-26-2011 10:23 AM
T1 CAS does not support outbound DNIS.
If you want it, and mnay more features, get T1 PRI instead.
Or you can ask telco to display a same number for all the calling extensions.
07-26-2011 02:00 PM
I was trying to connect this site without upgrading the key system.
Thanks.
07-26-2011 02:31 PM
Possibly it will be less expensive, and more feature rich, to just install IP phones at the site, and then use the T1 capacity for voice and between offices.
09-28-2011 02:52 PM
I found a way around it. I created a new partition and calling search space. I then created a translation pattern of @ and added the calling id for the system in that.
I have 20 sites like this so putting ip phones is not an option and it would cost to much to upgrade the systems to PRI.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: