cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
480
Views
0
Helpful
2
Replies
Highlighted
Enthusiast

CUE question

In order to sent call to CUCM, i have following options.

FXO Ports and CUE, i can configure CTI Route point and point it by plar connection.

E1 line and CUE, i can configure voip dial-peer and make destination pattern.

Lets say if i dont have CUE then and i have FXO lines. How can i manage to coonect it to CUCM.

I have made h323 gateway.

2 REPLIES 2
Highlighted
Enthusiast

CUE, Cisco Unity Express, really doesn't have anything to do with call routing. 

To do what you're asking, create a dial peer to CUCM that the connection plar on the FXO port will match.

HTH

Highlighted

My phone extension is 2222. No outgoing and incoming call is working

voice-port 0/0/0

trunk-group FXO

input gain -3

output attenuation -1

echo-cancel coverage 64

no comfort-noise

connection plar 2222

music-threshold -45

bearer-cap Speech

!

!

dial-peer voice 4 pots

description Mobile

destination-pattern 955......

fax rate disable

port 0/0/0

prefix 55

!

!

dial-peer voice 6000 voip

preference 1

destination-pattern 2...

voice-class codec 1

voice-class h323 1

session target ipv4:10.X.X.X

dtmf-relay h245-alphanumeric

req-qos guaranteed-delay audio

acc-qos guaranteed-delay audio

fax-relay ecm disable

fax rate 14400

fax nsf 000000

fax protocol pass-through g711ulaw

no vad