cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
634
Views
0
Helpful
2
Replies

DC 102 Recover on Expires timeout issue

Hello,

We have a new Cisco 3945E with IOS Version 15.1(4)M1 and IOS Image c3900e-universalk9-mz.SPA.151-4.M1.bin.

I'm trying to configure our SIP Trunk to work on this new machine, but it's not working. I'm calling from our other machine using ISDN to one of the configured numbers on the 3945. See attachments for config and debugs. I hear no ringback tone from the phone I'm calling from and it just disconnects after a few seconds.

Our SIP Trunk works just fine on our Cisco 3825 (IOS 12.4) and 3925(IOS 15.0) using the same configuration as in the attachments. I just can't figure out what else is missing or what is wrong with the setup in the 3945E.

If you need other debugs, please ask.

Thanks.

2 Replies 2

jasonca001
Level 1
Level 1

Hi  Grant Bagdasarian,

Do you get the solution for the issue of "VXML: Cisco-Data element behavior"? I encounter the same problem.

https://supportforums.cisco.com/thread/2110038

Could this be a DSP problem?

cmuc03#sh dspfarm

DSPFARM Configuration Information:

Admin State: DOWN, Oper Status: DOWN - Cause code: ADMIN_STATE_DOWN

Transcoding Sessions: 0(Avail: 0), Conferencing Sessions: 0 (Avail: 0)

Trans sessions for mixed-mode conf: 0 (Avail: 0), RTP Timeout: 600

Connection check interval 600 Codec G729 VAD: ENABLED

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: