03-08-2022 01:23 AM
Hi, is it possible to deploy E1 (E1 port module) and SIP (CUBE license) on a ISR4K Router at the same time?
Thank you.
03-08-2022 01:29 AM - edited 03-08-2022 07:39 AM
Yes it possible.
so you are planning to take two services one E1 and another sip trunk.
03-08-2022 02:00 AM
yes you can do same at a time, i have done more installation which can use E1 and SIP peering with providers.
Make sure your dial plan match based on the route, if not you will have large bills if you using E1 link to call Long distance call.
end of paying more bills.
03-08-2022 02:38 AM
Yes. Just take care with your dial peers. If you need more guidance then tell us more about the deployment.
03-08-2022 03:59 AM
As all other good points, I have seen customers using SIP and E1 on the same gateway. Either to take advantage of long distance or mostly as a backup. If one goes down, the other takes over.
You have to configure the dial-peers and play with the preference order for dial peer.
Hope this Helps
Cheers
Rath!
***Please rate helpful posts and if applicable mark "Accept as a Solution"***
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: