I'm currently struggeling with a FAX connected to an ATA-187 (firmware 9.2.3) dialing to PSTN in SRST (version 9.1, CUCM is also 9.1) mode.
The problem is that the ATA is sending the dialed number digit per digit (first invite only contains the PSTN access code of 0).
I have tried with KPML enabled and disabled. Disabling KPML worked for the 8961 phones which also have no dial plan on the phone.
Usually I have only a dial peer with destination pattern 0T to the PSTN. I have tried with dial peers that match the whole dialed number without any improvement. I have even tried with a local dial plan on the ATA but it sends a TRYING when the FAX starts to dial what the SRST responds with a Forbidden message.
Has anyone successfully used the ATA-187 with SRST?
If so, how did you configure it and what software versions have you used?
Here is my SRST config for the ATA-187 which works fine for answering calls:
Cisco Meeting Server 3.2 supports the Blast Dial feature. With Blast Dial, you can add a predetermined list of participants to a space where you configure blast dial. When any participant dials in to the space, all the other participants are dialed out si...
Shortcut ActionCtrl+W Close Meeting CenterCtrl+T Transfer filesCtrl+Z Undo last actionCtrl+Y Redo last undone actionCtrl+Alt+F Display Font Formatting dialog boxCtrl+Alt+O Share presentation or documentCtrl+Alt+A Share applicationCtrl+Alt+D Share DesktopC...
Do you experience the following error on Cisco Unity Connection: Sometimes when you try to play or upload Audio Files for greetings in Unity Connection under the Call Handlers such as the System Call Handler Opening Greeting, in Standard/Closed/Holi...
When an Ad hoc conference is triggered by an endpoint to escalate a point-to-point call into a three-way call.HQ-CUCM sends an API request via HTTPS to the Cisco Meeting Server to set up a conference. You can see from the event log of CMS that API us...