Dial-peer and Trunk

[anshsinh]

I have a topology like this-

iPphoneA->cucm->switch(sw1)->router(R1)->router(R2)->switch(sw2)->IPphoneB.

Both of my phones are registered to the Centralized CUCM.
My question is: Do I need any trunk , gateway or dial peers on any router for the call to work?

or will it work fine without any further configuration?

[Leo Salcie Tejeda · Accepted solution]

No, if both phones are registered to same CUCM there's not need of anything else.

Are both phone on <none> partition? If not, it could be related to CSS/Partition permissions.

Regards

[anshsinh]

Thank-you for answer. It cleared my doubt.