Dial Peer Matching Question

[Cristian Iconaru]

Hi guys,

does anyone know how the following dial peers are matched?

dial-peer voice 1 pots

destination-pattern 22

incoming called-number .

direct-inward-dial

port 0/0/0:15

!

dial-peer voice 2 pots

destination-pattern 22

incoming called-number .

direct-inward-dial

port 0/0/1:15

Thanks.

[paolo bevilacqua]

Both are matched, both will be used.

To use multiple port, use trunk-group configuration, not multiple DPs.

[Cristian Iconaru]

Hi Paolo,

the port is different.

Does it affect the matching process?

The config is for a VWIC3-2MFT-T1/E1.

If all 32 channels on port 0/0/0 are busy, will the calls go to the second one 0/0/1?

Thanks.

[paolo bevilacqua]

Calls go to both ports. Use trunk-group for easier configuration and more control.

[Cristian Iconaru]

Could you please explain this in detail? ...with both dial peers. i don't really understand how the calls go in/out if 2 ports are used.

Thanks

[paolo bevilacqua · Accepted solution]

DPs of same preference will distribute calls round-robin.

[Cristian Iconaru]

thanks.

[paolo bevilacqua]

Thank you for the nice rating and good luck!