Dial-peer prefix code

[Davy Ad]

Hello,

I have problem with my Dial-peer.
I defined dial-peer 2 with 4 codes to prevent all staff calling  International , except those who have the code.

I realized that I cannot call Emergency number like 911 or 9102 and some National number 908034567834.

Here are my Dial-peer configs;

dial-peer voice 1 pots

trunkgroup Group0

preference 5

destination-pattern 9[0-9][1-9]T   ( To call National)

dial-peer voice 2 pots

trunkgroup Group0

destination-pattern 9112200T  (To call international someone will need to dial 1122 (0049) .........)

prefix 00

Any help please?

DAk

[jones.jack]

Hello

I hope to share answers for the below questions:-

1-Can you share the full configuration which includes dial-peers (911 ,9102 ,etc...) and national number which have problems during outgoing calls?.

2-Router# show dial-peer voice summ  output.

Thanks

[Chandan Singh Takuli]

Hi Davy Ad

define  a new dial peer like this

dial-peer voice 3 pots

destination-pattern 9911

Forward-digits 3

i assume you you are using 9 for secondary dial tone but it depends how you call to a national no.? otherwise it will create issues with dial peer used to call national calls.

please mentione how you call to a national no. i mean prefix used.

[Chris Deren]

Is this CUCM or CME solution, why not use FAC rather than this prefix?

Chris

[Davy Ad]

Hello ,

It is CME and I use 9 to dial out.

Regards,

DAk

Message was edited by: Davy Ad

[Chris Deren]

I am pretty sure you can use FAC with CME on certain versions.

Chris

[Davy Ad]

Hello,

Here is the configuration attached please .

Any help would be appreciated.

DAk

Message was edited by: Davy Ad

[Carlo Poggiarelli]

Hi.

As Chris mentioned, (+5P C) starting from CME version 8.5 you can use Force Authorization Code feature to achieve your goal.

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmefac.html

HTH

Regards

Carlo