cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1389
Views
25
Helpful
3
Replies

Dial Peer

sourajit01
Level 1
Level 1

Can we have a single dial peer configured for inbound and outbound both? Kindly explain with examples. 

3 Replies 3

Read the document Jonathan posted, for sure. But the short answer is:

 

dial-peer voice 1 voip

  incoming called-number <used for inbound>

  destination-pattern <used for outbound>

 

If you are using e164 pattern maps, the commands are somewhat different.

 

Maren

HARIS_HUSSAIN
VIP Alumni
VIP Alumni

Consider below Scenarios

 

1) Scenarios -1VOIP to VOIP Calls Or POTS to POTS:- If you mean that same call should Hit the same dial-peer for both inbound and outbound then  You have to make sure Incoming DP match commands and outgoing dial-peer match commands are present in the same dial-peer.

 

For Example

 

 If A calling is coming from extension 2000 in CUCM going to SIP Provide 9055111222

 

dial-peer voice 1 VoIP

   incoming called number 9055111222

   destination-pattern 9055111222

OR

 

dial-peer voice 1 VoIP

   answer address 2000

   destination-pattern 9055111222

 

 

 

2) Scenario-2 If Phone is registered to CUCME 

In this case, it is not possible to match the same dial-peer as SIP/SCCP Phone will have default pots dial-peer associated when the register.

 

3) If VoIP to Pots:-  In this case also not possible as incoming dial-peer will match Voip dial-peer and outgoing dial-peer will match pots dial-peer

 

 

Also please let us know what you are tyring to achieve here maybe there is another way of doing same. 

 

*** Please rate helpful post; Mark "Accept as a Solution" if applicable

Thanks,
Haris

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: