03-06-2012 01:01 PM - edited 03-16-2019 09:58 AM
Hello all,
there is a question which must be very trivial but I'm stuck searching for answer.
There is a CCME system connected to PSTN through FXO ports and a few IP phones registered on the CCME system (SCCP protocol is in use). Destination pattern for outgoing calls is 9T, if my info is correct.
So, after users dial 9 and a proper number (911111, for instance) and the connection is established, they can see only 9 on their screens rather than 911111. Quite weird.
Unfortunately I don't have a complete config at my hand, so I'd be very grateful for any ideas before I tackle the issue.
Regards,
Tieken
03-06-2012 08:45 PM
Tieken,
What CCME version it is ?
Also, it's extreemly important to see the configuration to give precise ideas as to what must be causing this.
GP.
03-06-2012 08:57 PM
The CCME version is 8.6.
I shall attempt to get the config.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: