09-13-2009 11:34 PM - edited 03-15-2019 07:43 PM
Hi all,
Can I use the following destination-pattern 10 When I dial 108888 to remote site ?
dial-peer voice 10 voip
destination-pattern 10
session target ipv4:172.29.219.1
Thanks
Man
Solved! Go to Solution.
09-14-2009 03:33 AM
No, you have to extend your destination-pattern information.
One way could be to use: destination-pattern 10.... if you have fixed number of digits or 10T if there is more digits to come.
I would recommend to read whole document: http://www.cisco.com/en/US/docs/ios/12_3/vvf_c/dial_peer/dp_confg.html#wp1067900 + find information about wildcards used by dial-peers.
rate if this help
09-14-2009 03:33 AM
No, you have to extend your destination-pattern information.
One way could be to use: destination-pattern 10.... if you have fixed number of digits or 10T if there is more digits to come.
I would recommend to read whole document: http://www.cisco.com/en/US/docs/ios/12_3/vvf_c/dial_peer/dp_confg.html#wp1067900 + find information about wildcards used by dial-peers.
rate if this help
09-14-2009 05:30 PM
Hi KonradStepniewski
Thanks for your helpful information
Leung Che Man
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: