03-12-2013 02:46 AM - edited 03-16-2019 04:12 PM
Hi,
I have a VWIC-1MFT-E1 card in voice gateway 3800 series and configuration is:
network-clock-participate wic 0
network-clock-select 1 E1 0/0/0
no ip dhcp use vrf connected
!
ip cef
!
!
no ip domain lookup
!
isdn switch-type primary-4ess
voice-card 0
dspfarm
dsp services dspfarm
!
!
interface Serial0/0/0:15
no ip address
encapsulation hdlc
isdn switch-type primary-net5
isdn incoming-voice voice
isdn bind-l3 ccm-manager
isdn sending-complete
no cdp enable
!
controller E1 0/0/0
framing NO-CRC4
pri-group timeslots 1-31 service mgcp
!
!
!
voice-port 0/0/0:15
no echo-cancel enable
echo-cancel coverage 24
cptone FR
dial-peer voice 25 pots
description ### number 03.26.28.66.xx ###
incoming called-number 66..
direct-inward-dial
If I replace by a VWIC2-1MFT-T1/E1, what's difference between two card?
The configuration change?
Thanks in advance.
03-12-2013 03:10 AM
You will have to configure the "card-type" to E1.
And maybe paste in the old controller, interface and voice-port configuration.
Sent from Cisco Technical Support Android App
03-12-2013 03:57 AM
Hi Jean,
In VWIC2 -1MFT-T1/E1 card , you can use feature called Drop and Insert Multiplexing while in first generation cards , it was not supported.
Refer the link for Second generation cards with new features introduced:
http://www.cisco.com/en/US/prod/collateral/routers/ps5855/product_data_sheet0900aecd8028d2db.pdf
regds,
aman
03-12-2013 04:09 AM
The syntax (at least as of IOS 12.4) is:
card type e1 0 0
(the first 0 is the slot and the second 0 the WIC number)
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: