cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
752
Views
0
Helpful
1
Replies

disconnect cause=79 SERVICE_NOT_IMPLEMENTED

hello, I have a problem with international calls, the route pattern is correct, from the CUCM to GTW, I see the call in the GTW, and the marking is correct, it exits the dial-peer correct, but the call is disconnected and gives me busy tone. and the marking is correct, it exits the dial-peer correct, but the call is disconnected and gives me busy tone. this is my dial-peer configuration and debug..... and version the GTW is "c2900-universalk9-mz.SPA.154-3.M2.bin" technology is SIP-Trunk, all calls are less satisfactory international "00"

1 Reply 1

Jaime Valencia
Cisco Employee
Cisco Employee

I hardly doubt a telco will allow a call with an ANI of 4 digits to be placed.

   cisco-ani=7121

BTW, you want to use dialing, not "marking".

There's a spanish area in CSC as well, just click the language dropdown menu in the grey bar.

HTH

java

if this helps, please rate