cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
733
Views
0
Helpful
3
Replies

Do i need to confiure dial peer

ateeqs.net
Beginner
Beginner

Hi all,

Need your help, I am configuring the MGCP gateway do i need to configure the POTS dial peer for incoming calls.

Can some one please help me here      

3 Replies 3

Yes, please read this doc:

http://www.cisco.com/en/US/docs/ios/12_3/vvf_c/interop/intcnf1.html

Rate this if helps you.

Regards

Leonardo Santana

Regards
Leonardo Santana

*** Rate All Helpful Responses***

If I recall correctly (I have not worked with MGCP for a while) you do not need dial-peers for T1/E1/PRI ports as those get built automatically, but you need dial-peers for analog ports.

Chris

You can use dial-peer in the MGCP GW when the fallback feature is used.

You don't need icoming dial-peer in a MGCP GW on basic config.

For incoming calls in the CUCM MGCP gateway you must have a CSS with access to you DN partitions and

Alex

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers