07-08-2011 11:54 PM - edited 03-16-2019 05:51 AM
Hello
I got mix of endpoints Cisco_Phones and Polycom configured on CallManager Express. Cisco_Phones are configured as SCCP and Polycom as SIP.
Do I need to create Two Dial-peer for calling mobile ;; <<one for SIP and one for SCCP>>
Sip phones only work on configuring "dtmf-relay sip-notify"
SCCP phone only work on configuring "dtmf-relay cisco-rtp"
dial-peer voice 9 voip
destination-pattern 198........
session protocol sipv2
session target ipv4:10.10.10.100
dtmf-relay cisco-rtp
codec g711ulaw
!
dial-peer voice 10 voip
corlist outgoing International
destination-pattern198........
session protocol sipv2
session target ipv4:10.10.10.100
dtmf-relay sip-notify
codec g711ulaw
thanks
ST
Solved! Go to Solution.
07-09-2011 07:30 AM
you can configure following, GW would nego based on incoming call and for outgoing it will advertise both.
dial-peer voice 9 voip
destination-pattern 198........
session protocol sipv2
session target ipv4:10.10.10.100
dtmf-relay sip-notify cisco-rtp
codec g711ulaw
07-09-2011 07:30 AM
you can configure following, GW would nego based on incoming call and for outgoing it will advertise both.
dial-peer voice 9 voip
destination-pattern 198........
session protocol sipv2
session target ipv4:10.10.10.100
dtmf-relay sip-notify cisco-rtp
codec g711ulaw
07-09-2011 12:58 PM
Thanks it works
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: