Do I need Two DialPeer

[saquib.tandel]

Hello

I got mix of endpoints Cisco_Phones and Polycom configured on CallManager Express. Cisco_Phones are configured as SCCP and Polycom as SIP.

Do I need to create Two Dial-peer for calling mobile ;; <<one for SIP and one for SCCP>>

Sip phones only work on configuring "dtmf-relay sip-notify"

SCCP phone only work on configuring "dtmf-relay cisco-rtp"

dial-peer voice 9 voip

destination-pattern 198........

session protocol sipv2

session target ipv4:10.10.10.100

dtmf-relay cisco-rtp

codec g711ulaw

!       

dial-peer voice 10 voip

corlist outgoing International

destination-pattern198........

session protocol sipv2

session target ipv4:10.10.10.100

dtmf-relay sip-notify

codec g711ulaw

thanks

ST

[vandana · Accepted solution]

you can configure following, GW would nego based on incoming call and for outgoing it will advertise both.

dial-peer voice 9 voip

destination-pattern 198........

session protocol sipv2

session target ipv4:10.10.10.100

dtmf-relay sip-notify cisco-rtp

codec g711ulaw

[saquib.tandel]

Thanks it works