cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
639
Views
5
Helpful
3
Replies
Highlighted

DSP:s needed Router with one E1 and 2FXS

Hello,

An existing customer has a 2911 Router with one E1 PRI ISDN connected (CSS). (VWIC3-1MFT-T1/E1)

The customer has a PVDM3-32 as far as hardware DSP recources goes.

The customer wants to add an additional card supporting 2FXS interfaces (VIC3-2FXS/DID)

Do the customer also need an additional DSP card for that?

Regards,

Fredrik

Everyone's tags (5)
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Master

DSP:s needed Router with one E1 and 2FXS

That is correct.

Thank you for the nice rating and good luck!

View solution in original post

3 REPLIES 3
Hall of Fame Master

DSP:s needed Router with one E1 and 2FXS

Depends on how many E1 channels are used, and what other features are needed. Check:

http://www.cisco.com/web/applicat/dsprecal/dsp_calc.html

DSP:s needed Router with one E1 and 2FXS

The router only serves as an MGCP configured ISDN-Gateway.

Only G711 codec is in use.

I tried out your link and it seems to work, i would want an confirmation on my input:

I inputed the Router Model 2911

Slot0: VWIC3-1MFT-T1/E1 (E1)

Slot1: VIC3-2FXS/DID.

The webpage prefilles voice channel values.

I fill in the same number of channels as "low Complexity". (30 + 2)

(Only G711 codec used).

No additional services.

If everything is correct that means that the current PVDM32 is enough.

-------------

output

-------------

 
Router: 2911
IOS: 15.1(3)T
DSP Modules Required:

PVDM3-32: 1
DSP Module Allocation:
Router Slot 0:32 Voice (100%) 0 Available (0%)

PVDM Slot 0/0: PVDM3-32
Call Volume Allocation:
Router Slot 0LowMedHigh

Slot 0/0: VWIC3-1MFT-T1/E1(E1)30


Slot 0/1: VIC3-2FXS/DID2

Hall of Fame Master

DSP:s needed Router with one E1 and 2FXS

That is correct.

Thank you for the nice rating and good luck!

View solution in original post

CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards