05-07-2018 01:13 PM - edited 03-17-2019 12:46 PM
Hello Guys,
With the standard E.164 as to configure external phone number mask. I did the configuration, but, didn´t worked.
Thanks,
Wilson
05-07-2018 02:43 PM
what doesnt work? your phone number mask is not correct when you make an external call?
maybe you provider does not like E164 ANIs and you should strip to make it national number. can you explain a bit more, thx
05-08-2018 07:17 AM
Hi Dennis Mink,
Thanks a lot for Your contact. The configuration that I did is simple
My main number is 551198760000
My number is (example): \+551198765432
I putted the mask: +55119876XXXX
The call continues outoing with main number
Thanks,
Wilson
05-08-2018 07:19 AM
Hi there
Just wondering did you enable the check mark in the Route Pattern to enable the External Number Mask
Hope this helps!
Cheers
Rath!
***Please rate helpful posts***
05-08-2018 07:25 AM
Hi Cisco Rath!
Yes, I marked, but, continue receiving the main number.
Thanks,
Wilson
05-07-2018 03:23 PM
Hi there
Also please provide the call flow and the detailed explanation.
Hope this helps!
Cheers
Rath!
***Please rate helpful posts***
05-08-2018 07:19 AM
Hi Cisco Rath!
Thanks a lot for You contact. As I told previously I did the simple configuration:
Thanks a lot for Your contact. The configuration that I did is simple
My main number is 551198760000
My number is (example): \+551198765432
I putted the mask: +55119876XXXX
The call continues outoing with main number.
Thanks,
Wilson
05-08-2018 08:51 AM
Hi there
Could you send the debugs from the gateway and also the DNA ?
Also Make sure the Route List is not set to "Use External Number Mask" = Off.
Hope this helps!
Cheers
Rath!
***Please rate helpful posts***
05-08-2018 10:24 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide