I am having an issue when my phones register to the router in E-SRST mode. I am not able to call the phones internally; I just get a busy signal. The extensions on the 8841 phones for example look like \+12145551212. We would like to be able to dial the extensions local to the site via 4 digits so I would need to prepend the +12145551212 but where do I configure that? I am using one voice registration pool for the whole subnet the phone are in do I build that in there?
One solution for this will be to create a Dial-peer with higher preference than the ephone DN and then apply a translation rule to manipulate the digits however the way you want. Hope this helps
dial-peer voice 1002
voip destination-pattern 1019
preference 0 <<=====This dial peer has precedence and will match first.
preference 1 <<======Configure lower preference for prebuilt DN.
Cisco Webex Calling is a cloud service that offers enterprise-grade calling features delivered from the Cisco Webex cloud. This platform is part of the complete Webex collaboration suite that serves the calling, messaging, meeting, team collaboration and...
Cisco SX20 camera moving left right and shaking continuously. We have factory reset the devices still it is a same problem. Even change the camera of working devices with issue devices still the problem.Now the software version of the device is ...
Hello Experts. We would like to write macro to create a button to switch sources during a call. The only possible view today is content on upside and participants down. This is not the best experience for user's perspective. Someone, could ...
Joining Webex Meetings just got significantly faster – with fewer clicks and less time that’s needed to get into your meetings on desktop and mobile apps.
With our email template simplification, you can enjoy a sin...