cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
867
Views
0
Helpful
22
Replies
Hall of Fame Master

E1 conenction is showing Deactivated

isdn network side is configured under interface, not controller.

After which you have to shut/no shut.

Beginner

E1 conenction is showing Deactivated

HI Paolo,

if i am not wrong, its already configured in the router.

encapsulation hdlc

no logging event link-status

isdn switch-type primary-qsig

isdn overlap-receiving T302 7500

isdn incoming-voice voice

please let me know if it is wrong. thanks

Hall of Fame Master

E1 conenction is showing Deactivated

You may have the PBX in loopback causing this.

Beginner

E1 conenction is showing Deactivated

HI Paolo,

I configured the interface as isdn network side, still no luck.

Advisor

E1 conenction is showing Deactivated

Hi Pavan,

Did u try configuring Clock on router?

Can u cross-check the parameters one by one u have configured on router with EPABX guy since after u change network on your side EPABX needs to be on Slave ?

regds,

aman

Advisor

E1 conenction is showing Deactivated

Hi ,

The network -clock are missing.

I doubt this is problem .You need to configure network-clock participate

regds,

aman

Highlighted
Beginner

E1 conenction is showing Deactivated

Hi Aman,

sure i will try this and will get back to you.

Advisor

E1 conenction is showing Deactivated

Hi,

it is slave configured

Global ISDN Switchtype = primary-qsig

ISDN Serial2/0:15 interface

        dsl 0, interface ISDN Switchtype = primary-qsig

         **** Slave side configuration ****

regds,

aman

CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards