E1 config and check

[divine007]

Hello All,

I have an E1 link from my provider with the pool of numbers 335059xx and want to configure my E1 and CCME to do the translation

Can someone kindly hint me

Thanks

[V.Naveen Kumar]

Plz refer below link for basic conf.

http://www.cisco.com/univercd/cc/td/doc/product/access/acs_serv/as5800/58sw_icg/swconfig.htm#xtocid445814

[Harmit Singh]

Hi Divine,

An easy way of mapping the pool of DIDs to extensions is by using the following command under telephony-service:

dialplan-pattern tag pattern extension-length extension-length [extension-pattern extension-pattern | no-reg] [demote]

Please refer the following link for more details on how to configure this:

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/command/reference/cme_d1ht.html#wp1061986

HTH.

Regards,

Harmit.

[divine007]

Am in Cameroon and i have thesame issue here is my config

controller E1 0/1/0

linecode ami

pri-group timeslots 1-16

!

interface Serial0/1/0:15

no ip address

encapsulation hdlc

isdn switch-type primary-net5

isdn incoming-voice voice

no cdp enable

!

dial-peer voice 54 pots

destination-pattern 0T

port 0/1/0:15

incoming called-number .

direct-inward-dial

!

isdn test call interface serial 0/0/0:15 00023775697183

Here is my error message

Nov 29 10:35:42.928: ISDN Se0/1/0:15 EVENTd: isdn_is_bchannel_available: No Free B-channels

Nov 29 10:35:42.928: ISDN TEST CALL #0 to 0023775697183 at 64 Kbps failed aborting the remaining 1 calls

my card is NM-2CE1T1-PRI on a 2800 series router