04-21-2008 06:14 AM - edited 03-15-2019 10:11 AM
Hi, I have an hour window Thursday and Friday morning to test an E1 CME router setup with 8 channels, having never configured an E1 before I'm trying to cover all bases and am looking for some advice and clarification based on the config below.
I'm sure the customer has 8 channels, like BRI I presume this will allow 16 concurrent calls? Can anyone see any issues with the config? Also are there any recommended configuration options I should add?? Any help would be greatly appreciated.
Thanks,
Craig.
network-clock-select 1 E1 0/3/0
isdn switch-type primary-net5
controller E1 0/3/0
pri-group timeslots 1-8,16
interface Serial0/3/0:15
no ip address
encapsulation hdlc
isdn switch-type primary-net5
isdn incoming-voice voice
isdn sending-complete
no cdp enable
04-21-2008 06:21 AM
Hi, seems it's all good, your pri will do as many calls as channels (8).
04-21-2008 06:37 AM
Thanks. What would the config look like with 17 Channels ?
04-21-2008 07:59 AM
pri-group timeslots 1-18.
This to account the D channel.
04-21-2008 09:08 AM
you'll also need
network-clock-participate wic 0 - this will use the network clock for timing.
As mentioned by previous poster your configuration will only allow for 8 concurrent calls (1 per channel).
Don't forget to configure your voice-port cptone and also your dial-peers.
HTH
04-21-2008 09:54 AM
Thanks Guys, I now feel confident I can get what I need done with the limited testing time allocated.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: