E1 ISDN setup Claro-Telmex in Colombia

[Miquel Bover]

Hello Team,

I have to setup an ISDN E1 (30 channels) in Colombia, the Service Provider is Claro (Telmex). I have doubs regarding the ISDN switch-type to use.

Is there anyone who have a ISDN E1 setup for Claro in Colombia?

!
controller E1 0/1/0
framing no-crc4
clock source line primary
line-termination 75-ohm
pri-group timeslots 1-31
!
!
interface Serial0/1/0:15
no ip address
encapsulation hdlc
isdn switch-type ????????
isdn incoming-voice voice
isdn negotiate-bchan
no cdp enable
!

!

Thank you in advance

Best regards!

Miquel Bover

[mtorres.plannet]

Hello Miquel, 

Did you find support with this issue? I have the same case right now.

Best regards,

Maricela Torres.

[Miquel Bover]

Hello,

Please, see below the right setup:

controller E1 0/1/0
  clock source line primary
  pri-group timeslots 1-31

interface Serial0/1/0:15
  no ip address
  encapsulation hdlc
  isdn switch-type primary-5ess
  isdn incoming-voice voice
  isdn negotiate-bchan
  no cdp enable

COBOGVGW01#sh controllers E1 0/1/0
E1 0/1/0 is up.
Applique type is Channelized E1 - balanced
No alarms detected.
alarm-trigger is not set
Framing is crc4, Line Code is HDB3, Clock Source is Line Primary.
International Bit: 1, National Bits: 11111
Data in current interval (34 seconds elapsed):
0 Line Code Violations, 0 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
Data in Interval 1:
0 Line Code Violations, 0 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs