03-18-2013 01:04 PM - edited 03-16-2019 04:19 PM
Hello guys,
We have a CUCM 8.6 cluster and we are trying to communicate with an Avaya Ip Office.
There is a 2921 gateway registered as an MGCP gateway in the CUCM and this gateway have a QSIG E1 to the Avaya.
Calls are working in both directions but the calling name is not displayed just in the Avaya side.
As i understand, the calling name is passed as a Facility in the QSIG signalling but i can´t find in the debugs where it is.
I already take a look at the interoperability portal but that documents do not apply to the Avaya IPO that we are using.
Anyone have already done this kind of integration? Is there any trick?!
Is there a debug that i can check the facilitys that is sent?
Thanks!
Fernando
03-19-2013 05:57 AM
Add the following to the GW:
voice service voip
qsig decode
HTH,
Chris
03-19-2013 06:26 AM
Dear
Call manager - gateway - set the call party selection to originator and call party presentation to Allowed.
Thank you
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide