Let's say our CUCM environment is a campus with 5 buildings around town, and one gateway and one PRI that all calls go in and out of. If we don't have CER can we just configure all calls to 911 to go out with a particular callerID and coordinate with the carrier on the address?
Yes, you can do that, but check with service provider too. You'll lose the callback functionality though.
Recent CUCM versions also have a basic "native" emergency calling feature that you might want to do some research on. Phones' device pools need to be organized by physical locations (usually are), and there's a limit of up to 100 sites. You don't get onsite alerts or emails with this though:
There are cases/situations where we have to configure custome CPTONE to resolve FXO disconnect issue. Following are situations which can arise due to FXO disconnect issue:
Phone A calls Phone B, Phone B does not answer. Phone A then goes on-hook but Phon...
Cisco announced major enhancements today to Webex Contact Center. Learn more about the highlights including
better support for the needs of large contact centers worldwide
improvements in the agent and cust...
SymptomsI’m doing a factory reset on the mobile board and it’s giving me the same issues that I wasn’t able to also send over last time. It says that it can’t connect to the server because of a firewall (we don’t have one) and then sometimes it...