07-14-2011 02:01 PM - edited 03-16-2019 05:57 AM
If I'm not wrong in early offer , codec are negotiated withen the invite message
but with delayed offer the SDP is send with the 200 and the answer is send back with the ACK
so suppose I have call manager is SIP mod
Phone A : 711
Phone B : 729
phone A will call phone B localy
Case1
in Early offer I must hear a fast busy just after dialing the number of phone B
Case2
in Delayed offer I will hear the fast busy when I try to answer the call
my question how to force CME to use delay offer
because every time I try to call I have Case1 result
What configuration has to be done in CME ?
Regards
Solved! Go to Solution.
07-18-2011 02:41 PM
You can see a delayed offer call if going from sccp to h323 to sip.
Create an h323 dial peer pair so that dial ing a number from your sccp phone causes a call to leave the router and loop back to itself . Use number translation profiles to break the loop and forward to your sip end point as delayed offer. Use codec transparent on the dial peers.
Good luck. Adam
Sent from Cisco Technical Support iPhone App
07-17-2011 07:59 PM
Hi, linuxchild
please provide the following,
1. detail call flow, like phone A - sip - CME - sip - phone B ?
2. show version, show run of your CME
3. debug ccsip message, debug voip ccapi inout when the call failed
Rgds/Randy
07-18-2011 12:15 AM
Hello
thank you for your answer
In fact I'm doing this on purpose , I just want to prove the theory of early and delayed offer
I was able to simulate case 1
but I have pb to create or simulate case 2
the call flow is
Phone A G711 SIP ----CME----Phone B G729 SIP
version 15.1(4)M
again this is for my lab , to see the difference between both methods
so is there a way to create delay offere with CME
Kind Regards
07-18-2011 01:59 AM
Hi, Linuxchild
To my knowledge, there is no way that we can do it if the originating side is using EO.
Rgds/Randy
07-18-2011 02:11 AM
Hi
so you mean that CME SIP mode always use EO ??
Regards
07-18-2011 02:41 PM
You can see a delayed offer call if going from sccp to h323 to sip.
Create an h323 dial peer pair so that dial ing a number from your sccp phone causes a call to leave the router and loop back to itself . Use number translation profiles to break the loop and forward to your sip end point as delayed offer. Use codec transparent on the dial peers.
Good luck. Adam
Sent from Cisco Technical Support iPhone App
07-19-2011 12:42 AM
Thank you
I will test it tonight and let you know
Regards
07-20-2011 12:14 AM
Hi
Thank you Adam , your config allowed me to simulate delayed offer
I taged this question as solved because the main original question is solved
but I would like to ask you few questions :
1: can I impose early offer if I have a call flow SCCP phone >> H323 >>H323>> SIP phone
remarks I noticed but I did not have the time to investigate
PhoneA SIP : g729
PhoneB SIP : g711a
PhoneC SCCP : G729
when calling from C to A or B : call is ok and it is delayed offer
when calling from A to B or B to A : fast busy and early offer
when calling from A to C or from B to C : ringing ( I did not check if it is earl offer or delayed offer ) , I see the calling number on phone screen , but when answering I hear nothing and the calling phone keep having a ring back tone
I will try to investigate then be back to you , to give the explanation or to ask you a question
Regards
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide