cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
427
Views
0
Helpful
2
Replies

Enable 100rel in the CP 8800 series CUCM version

veniciusgp
Level 1
Level 1

Dear,

 

Is it possible to enable 100rel on the CP 8800series device with enterprise firmware? Although this device is with CUCM firmware I am homologating with a third party pabx. I am using sepmacaddress.cnf.xml to perform the settings through auto provisioning. Is there any parameter in sepmacaddress.cnf.xml that allows 100rel to be activated? By default, 100rel is disabled

 

Best Regards

2 Replies 2

No 100Rel isn't set in the XML file. Attached a sample

Dear Friend,

 

Actually 100rel was not set because I do not know if there is a possibility. Is there any parameter that can be set in the xml that allows 100rel to be activated? Attached is the XML used

 

Best Regards