Ephone_dn translation-profile

[jcounter]

I have a need to make restrict a Ephone from Dialing out. I've

implemented the below config. But it doesnt seem to work.

!

voice translation-rule 10

rule 2 reject /9../

rule 3 reject /9......../

!

voice translation-profile LOBBY

translate called 10

!

ephone-dn 2 dual-line

number 2501

label Lobby x2501

description 8282501

name Lobby

translation-profile outgoing LOBBY

!

I know this is possilbe with CorList but need to try and get something else to work. The phone should only be able to call internal extensions. No 9. dialing permitted.

Any thoughts?

[paolo bevilacqua]

Hi, translation profile should be applied incoming, not outgoing. Think the ephone-dn like a fxs port.

Hope this helps, please rate post if it does!

[jcounter]

i Tried that too... No luck.

[William Bell]

Maybe I don't follow what you are trying to do but I would think a COR configuration would work out better. Example:

dial-peer cor custom

name 911

name offnet

dial-peer cor list call911

member 911

dial-peer cor list callOffNet

member offnet

dial-peer cor list Lobby

member 911

dial-peer cor list EndUser

member 911

member offnet

dial-peer voice 911 pots

description 911Calling

corlist outgoing call911

dial-peer voice 10 pots

description local_10_digit

corlist outgoing callOffNet

..other dial peers..

call-manager-fallback

cor incoming Lobby -

cor incoming EndUser -

Hope that helps.

Regards,

Bill

[William Bell]

Apparently I didn't fully read your post. My apologies. You could try using the following translation:

rule 1 reject /^9.*/

Also, when you do a 'test voice translation-rule ' what are your results?

Have you used 'debug voice ccapi' to check the behavior with a test call?

[jcounter]

when I performed the test translation it reports back Call Blocked. havn't done debug yet. But the calls are successfully reaching the PSTN.