cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Cisco Community Designated VIP Class of 2020

105
Views
5
Helpful
4
Replies
Beginner

External Transfer Problem

Hi Guys

I have a Call Handler setup on Unity Version 11 and CUCM Version 11, each Caller Input directs to a hunt pilot

For some reason when dialling from an external number, line goes dead when using the caller inputs.

Thanks

M

 

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Beginner

Kindly check mtp on sip trunk

Kindly check mtp on sip trunk as well as configure 'midcall-signal pass media-change' on sip gateway. If problem still persist collect & share 'debug ccsip message' & 'debug ccapi inout' from gateway and traces from CUCM for impacted call.

Regards,

Kunal

View solution in original post

4 REPLIES 4
Cisco Employee

Looks to be a codec issue.

Looks to be a codec issue. Can you check the codec/region settings throughout in the call flow for  External Calls right starting from the Trunk/Gateway till it reaches CUC and provide callers with the option of pressing DTMF.

Regards

Deepak

Beginner

Hi Maheer,

Hi Maheer,

Can you please share the call flow ? Is the affected call came from h323, Sip or mgcp ?

h323/sip/mgcp--CUCM(CTI RP) -- CUC -- Call Handler -- Caller Input to ext

In case of h323/sip, what is the status of mtp? is it checked or unchecked?

Thanks!

Kunal

Beginner

Hi

Hi

It's a SIP Gw and mtp is unchecked on the trunk 

Highlighted
Beginner

Kindly check mtp on sip trunk

Kindly check mtp on sip trunk as well as configure 'midcall-signal pass media-change' on sip gateway. If problem still persist collect & share 'debug ccsip message' & 'debug ccapi inout' from gateway and traces from CUCM for impacted call.

Regards,

Kunal

View solution in original post

CreatePlease to create content
Content for Community-Ad
FusionCharts will render here