02-12-2015 06:35 AM - edited 03-17-2019 01:56 AM
Hello,
I have a CUCM, and a SIP Trunk with Avaya. All the calls are done by this SIP Trunk, and it is working normally.
I have one ATA (Audio Code), that is connected in a Device Fax.
Please, I would like to know if is possible to send a Fax with this ATA using the SIP Trunk!!
Regards,
Bruno
02-12-2015 08:21 AM
Hi brunofalco,
You can used ATA to connect and send fax.
For additional info on supported call flow refer below link.
http://www.cisco.com/c/en/us/support/docs/voice-unified-communications/unified-border-element/115742-fax-modem-call-flows-00.html#anc10
HTH,
Regards,
Mohammed Noor
02-12-2015 09:35 AM
Hi Mohammed,
Tks for the infos.
But I´m using a non Cisco ATA....it is from Audio Code.
And, I´m not using a VG, or a GW.
The call flow is ATA >> CUCM >> SIP Trunk
Is it possible??
Regards,
Bruno
02-12-2015 09:37 AM
02-12-2015 09:44 AM
Mohammed ,
But do I need some specific configuration?
I have created a SIP Trunk, SIP Profile, sip trunk security profile....
02-12-2015 09:48 AM
MTP should be unchecked
Regards,
Mohammed Noor
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: