cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
296
Views
0
Helpful
1
Replies

FAX connected to FXS with an incoming SIP DID number

rassoul.ghaznavi
Beginner
Beginner

Hi,

I have got a fax machine connected to fxs on Cisco call manager express,
I have got a SIP trunk set up on the Cisco box and a  DID number for FAX, so basically a sip call will come in and connect to the fxs and fax,
problem I have got is outgoing faxes work with T38 standard (as provider says) setup on voice servive voip, but incoming faxes doesn't work at all !,
Do I need to have special config to get this working ?
Here is the config :

voice service voip
allow-connections h323 to h323
allow-connections h323 to sip
allow-connections sip to h323
allow-connections sip to sip
supplementary-service h450.12
no supplementary-service sip moved-temporarily
no supplementary-service sip refer
fax protocol t38 ls-redundancy 0 hs-redundancy 0 fallback pass-through g711alaw
no fax-relay sg3-to-g3
sip
  registrar server expires max 3600 min 3600
  localhost dns:abc.local
  no update-callerid

sip-ua
credentials username xxxx password 7 xxxx realm 1.2.3.4
authentication username xxxxpassword 7 xxxx
no remote-party-id
retry invite 2
retry register 10
timers connect 100
registrar ipv4:1.2.3.4:5060 expires 3600
sip-server ipv4:1.2.3.4
connection-reuse
host-registrar

dial-peer voice 30 pots
destination-pattern 8370
port 0/0/1
no sip-register

dial-peer voice 1 pots
preference 7
port 0/0/1

voice-port 0/0/1
ring cadence define 50 10
no echo-cancel enable
playout-delay fax 60
cptone AU
timeouts wait-release 1
impedance 600c
station-id number 8370
caller-id enable

1 Reply 1

dwillie
Beginner
Beginner

don't you need to configure a "dial-peer voice x voip" for the voip call leg?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers