cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
405
Views
0
Helpful
1
Replies

Faxs are not sending & receiving completly ...

hi all,

I have ATA 186 connected with CCM 6.0 & MGCP is configured for Voice Gateway ... if i am sending huge number of faxs together then my fax are not going completly ( means half of the page is going only rest blank ) i dont have any errors on controller .... below is my configured for VG, can any one tell what could be the reason

VoiceGW#sh run
Building configuration...

Current configuration : 2795 bytes
!
version 12.3
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname VoiceGW
!

!
network-clock-participate wic 0
network-clock-participate wic 1
network-clock-select 1 E1 0/0/0
network-clock-select 2 E1 0/1/0
no aaa new-model
ip subnet-zero
!
!
ip cef
!
!
no ip domain lookup
ip ips po max-events 100
no ftp-server write-enable
isdn switch-type primary-4ess
!
voice-card 0
no dspfarm
!
voice service voip
allow-connections h323 to h323
fax protocol pass-through g711alaw
!
voice class codec 1
codec preference 1 g711alaw
!
ccm-manager fallback-mgcp
ccm-manager redundant-host 172.16.0.22
ccm-manager mgcp
ccm-manager music-on-hold
ccm-manager config server 172.16.0.21 
ccm-manager config
!
controller E1 0/0/0
framing NO-CRC4
pri-group timeslots 1-31 service mgcp
!
controller E1 0/1/0
  framing NO-CRC4
pri-group timeslots 1-31 service mgcp
!
interface FastEthernet0/0
ip address x.x.x.x x.x.x.x
duplex auto
speed auto
!
interface FastEthernet0/1
no ip address
shutdown
duplex auto
speed auto
!
interface Serial0/0/0:15
no ip address
isdn switch-type primary-net5
isdn incoming-voice voice
  isdn bind-l3 ccm-manager
isdn bchan-number-order ascending
no cdp enable
!
interface Serial0/1/0:15
no ip address
isdn switch-type primary-net5
isdn incoming-voice voice
isdn bind-l3 ccm-manager
isdn bchan-number-order ascending
no cdp enable
!
voice-port 0/0/0:15
!
voice-port 0/1/0:15
!
mgcp
mgcp call-agent 172.16.0.21 2427 service-type mgcp version 0.1
mgcp dtmf-relay voip codec all mode out-of-band
mgcp rtp unreachable timeout 1000 action notify
mgcp modem passthrough voip mode nse
mgcp package-capability rtp-package
no mgcp package-capability res-package
mgcp package-capability sst-package
no mgcp package-capability fxr-package
mgcp package-capability pre-package
no mgcp timer receive-rtcp
mgcp sdp simple
mgcp validate domain-name
mgcp validate call-agent source-ipaddr
mgcp fax t38 inhibit
mgcp rtp payload-type g726r16 static
mgcp bind control source-interface FastEthernet0/0
mgcp bind media source-interface FastEthernet0/0
mgcp rtp payload-type clear-channel static
!
mgcp profile default
!
!
!
dial-peer voice 2 pots
application mgcpapp
port 0/0/0:15
!
dial-peer voice 3 pots
application mgcpapp
port 0/1/0:15
!
gateway
timer receive-rtp 1200
!
!
!
!
line con 0
  password xxxxx
login
line aux 0
line vty 0 4
password xxxx
login
line vty 5 15
password xxxx
login
!
scheduler allocate 20000 1000
!
end

VoiceGW#

Regards,

Nasry

1 Reply 1

guys !!!!

what happened ??? any clue or any solution ????

Regards,

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: