cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

89
Views
0
Helpful
0
Replies
Highlighted
Beginner

fx0 to sip not working

I have an analog line coming in from the provider and I need to send it to the IPPBX.  I have gone back to basics and I can't seem to get the analog line to pass the call to the SIP Stack.  I have debugged ccsip and vpm signal.  I am seeing the call come in the debug, but only on the fx0 port the call never reaches the sip stack.  Call just rings and it sound like it is picked up and get dead air.  The call flow is as follows

PSTN Call -> FXO 0/0 -> Cisco 2911 -> session target IPPBX on extension 1000

 

 

voice-port 0/0

 connection plar 1000

 caller-id enable

!

!

dial-peer voice 100 pots

 incoming called-number .T

 direct-inward-dial

 port 0/0

!

!

dial-peer voice 1000 voip

 destination-pattern .T

 session target ipv4:10.41.100.2

 

CreatePlease to create content
Content for Community-Ad
Future of Work Virtual Summit Day 5

Cisco COVID-19 Survey