I have Telephony setup based in Saudi Arabia,Qassim, 1 VG-4331 with FXO card and two analog lines, CUCM-12, CUC-12.
Everything is working fine, except two issues
If i call from outside after greetings is played, if i disconnect the call with out any input, FXO hangs.
while if i transfer call to operator or extension, call is established and when far user disconnects the call , FXO shows still busy and on ip phone call is still active and if i end the call on ip phone fxo port is released.
Outgoing Call - call get disconnects after 1min automatically.
Below is my router config
voice service voip allow-connections h323 to h323 allow-connections h323 to sip allow-connections sip to h323 allow-connections sip to sip supplementary-service media-renegotiate redirect ip2ip fax protocol t38 version 0 ls-redundancy 0 hs-redundancy 0 fallback none ! voice class codec 1 codec preference 1 g711ulaw codec preference 2 g711alaw codec preference 3 g729r8 ! voice class h323 1 h225 timeout tcp establish 3 h225 timeout setup 3 ! ! ! voice class dualtone-detect-params 1 freq-max-deviation 25 freq-max-power 0 freq-min-power 13 freq-power-twist 4 cadence-variation 4 ! voice class custom-cptone KSA dualtone reorder frequency 425 cadence 250 250 dualtone disconnect frequency 425 cadence 500 500 ! voice class custom-cptone FXO_SA dualtone disconnect frequency 425 cadence 500 500 ! voice class custom-cptone CUSTOM-SIEMENS dualtone disconnect frequency 425 cadence 425 325 250 500 ! voice class custom-cptone CUSTOM-ERICSSON dualtone disconnect frequency 425 cadence 325 325 ! voice class custom-cptone CUSTOM-FETEX dualtone disconnect frequency 425 cadence 375 375 ! voice class custom-cptone CUSTOM-ALCATEL dualtone disconnect frequency 425 cadence 375 375 !
interface GigabitEthernet0/0/0 ip address 192.168.1.2 255.255.255.0 negotiation auto h323-gateway voip interface h323-gateway voip h323-id H323
Join this featured IT Admin Control Hub session where you’ll hear about the improved Meeting diagnostics capability in Control Hub which provides IT Admins richer insights about their meetings, the participants and the quality of service. See metrics to h...
This document explains how to register a Cisco TelePresence or WebEx device to Cisco WebEx Cloud Service Using API or Local Web Interface use. This procedure is applicable for Collaboration Endpoint Software 9.8 and later. In previous versi...
SymptomsCER or other Cisco UC platform servers fail to boot with an error message immediately on startup similar to:FATAL: Could not load /lib/modules/2.6.32-642.el6.x86_64/modules.depDiagnosisYou do some searching, and think it's related to this bug - CS...
This Log Analysis tool helps you analyze the call processing and the signaling information collected by the XSLog logs from the Cisco BroadWorks system. This tool also supports a broad range of other Cisco products and technologies...