FXO port on 2921

[gpworld]

I have a VIC2-4FXO that shows up in inventory but not in running config.  Anyone?  I have re-seated and also moved the card.

[Amine Nouasri]

Can you tell us what IOS file the router is configured to use?

[gpworld]

15.1

[paolo bevilacqua · Accepted solution]

Need PVDM3 and UC license to enable the card.

[gpworld]

Yeah the client had not installed PVDM before it shipped to the site.  Configuring the DSP's is when i finally noticed the missing PVDM's ...

Thanks to all that replied.  It was the missing PVDM.

[paolo bevilacqua]

Thank you for the nice rating and good luck!

[Amine Nouasri]

Probably you don't have the UC (Unified Communications) feature activated. You can do show license feature to verify this.

If it is the case, check this link on how the activate a feature on a ISR G2:

http://www.cisco.com/en/US/docs/routers/access/sw_activation/SA_on_ISR.html

Please rate helpful answer!

[abidnazeer]

Check show version and show diag to check its recognized or not

then try voice-card command