fxo ports example

[pamirian76]

hi,

have a 2801 with 1 4 ports fxo card.

let,s say I have 4 1FL lines. 3 of them are cascade and 1 line is a reserved line DID for a store owner.

the first 3 are in a trunk group 1

and I have this,

voice-port 0/0/0

trunk-group 1

connection plar opx 299

caller-id enable

!

voice-port 0/0/1

trunk-group 1

connection plar opx 299

caller-id enable

!

voice-port 0/0/3

trunk-group 1

connection plar opx 299

caller-id enable

!

voice-port 0/0/4

connection plar opx 212

caller-id enable

--> so 299 is my auto attendant and 212 is my own extension.

dial-peer voice 1000 pots

description *** OUTGOING CALLS ***

translation-profile outgoing OUTGOING

trunk-group 1

preference 1

destination-pattern .T

forward-digits all

so any calls going outside I want them to use 1 of the 3 lines.

what I want to do when calling from my 212 extension outside is to tell the cme use port 4. so port 4 is a did reserved for my phone 212. I don't want phone 212 to use one of the trunk-group lines.

how would I do that?

thank you!!

[pamirian76]

I just came up with this what do you think?

anything more elegant?

dial-peer voice 1000 pots

corlist outgoing call-trunk-group

description *** OUTGOING CALLS ***

translation-profile outgoing OUTGOING

trunk-group 1

preference 1

destination-pattern .T

incoming called-number .

forward-digits all

!

dial-peer voice 1000 pots

corlist outgoing CALL-DID-PORT003

description *** OUTGOING CALLS ***

translation-profile outgoing OUTGOING

port 0/0/3

preference 1

destination-pattern .T

incoming called-number .

forward-digits all

!

ephone-dn 14 dual-line

bla bla bla....

corlist incoming CALL-DID-PORT003

corlist outgoing CALL-DID-PORT003

ephone-dn 15 dual-line

bla bla bla....

corlist incoming call-trunk-group

corlist outgoing call-trunk-group

even better have a ephone-dn template and assign the template to the ephone-dns.

i have not tested it so not sure if this will even work but it should...

please let me know.

thanks.