cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
538
Views
0
Helpful
1
Replies

FXO RJ21 termination - 12FXO

J_Vansen_S
Participant
Participant

Hi All, 

 

SM-X-8FXS/12FXO

 

A client has a bunch of FXO lines thus we are proposing the 12FXO Single-wide service module instead of several NIM-4FXO cards

 

How do i terminate FXO lines with this RJ21 connector as needed on this High-Density Analog Voice Module, as we're only familiar with the RJ11 NIM ports on standard routers plugged straight from TELCO side to our router

 

https://www.cisco.com/c/en/us/products/collateral/routers/4000-series-integrated-services-routers-isr/datasheet-c78-739991.html

 

Appreciate any advise

1 Reply 1

Muhammad Awais Khan
Cisco Employee
Cisco Employee

Hi,

 

From service Provider, your connections will be terminated /available on a IDF/MDF board in your telco room. From Telco board/IDF/MDF you will raise a RJ21 Cable which will be having RJ21 connector on one end that will be connected to Router FXO NM while other side will be having Cable pairs which you can then terminate on the board.  Have a look on below link:

 

https://www.cisco.com/c/en/us/td/docs/routers/access/interfaces/nm/hardware/installation/guide/connhda.html

 

On Voice Gateway, you will be seeing 12 FXO ports 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers