02-23-2016 09:45 AM - edited 03-17-2019 05:58 AM
Hello,
I have an FXS card going into a 1921 router. I have documentation for the FXS card configuration on the router. Can someone tell me where I need to configure this in CM?
Thanks,
Replies rated
02-23-2016 10:11 AM
That depends on CUCM version, and protocol to be used.
02-23-2016 10:19 AM
I believe its SIP on 10.5
02-23-2016 10:23 AM
Then in CUCM all you need is to configure a SIP trunk pointing to the GW and all the relevant call routing info (RP/RL/RG)
I'd personally go with H.323 or MGCP for old TDM interfaces and leave SIP for communication between other clusters, and SIP trunks to the PSTN, just my personal preference.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide