04-24-2016 10:13 PM - edited 03-17-2019 06:41 AM
Hello,
WE ordered Cisco NAME: "CISCO2911/K9", DESCR: "CISCO2911/K9 chassis, Hw Serial#: FCZ201070FU, Hw Revision: 1.0"
PID: CISCO2911/K9 , VID: V07 , SN: FCZ
We are planning to connect FXS card on it to configure Analog FAX machine below is the description of the card
Product |
Description |
VIC3-4FXS/DID |
4 PORT FXS OR DID VIC |
Is the Router 2911 support for this card..there are EHWIC1 to WHWIC3 card are available on the router can we able to connect the VIC3-4FXS/DID card on this slot.
Solved! Go to Solution.
04-24-2016 11:22 PM
Hi Vijay,
As per page 6 of the following link it is supported on 2911
http://www.cisco.com/c/dam/en/us/products/collateral/routers/1900-series-integrated-services-routers-isr/aag_c07_563807.pdf
Manish
04-24-2016 11:22 PM
Hi Vijay,
As per page 6 of the following link it is supported on 2911
http://www.cisco.com/c/dam/en/us/products/collateral/routers/1900-series-integrated-services-routers-isr/aag_c07_563807.pdf
Manish
04-25-2016 12:43 AM
hello manish,
Thanks for replay...on page 6 it shows the 2901-3945E will the consider as for the CISCO2911/K9..
04-25-2016 12:51 AM
Yes, it shows the whole series between 2901 and 3945, rather than writing all of them separately.
Manish
04-25-2016 01:12 AM
04-25-2016 01:28 AM
[+5] to Nadeem.
Vijay,you can refer the Table 2.
VIC3-4FXS/DID is supported on Cisco 2900 series routers.
http://www.cisco.com/c/en/us/products/collateral/interfaces-modules/ip-communications-voice-fax-network-modules/product_data_sheet0900aecd801c595e.html
regds,
aman
04-27-2016 04:56 AM
Hello Manish ,
Is the VIC3-4FXS/DID card required SM-NM-ADPTR to connect on the cisco 2911 router ...
or i can directly connect VIC3-4FXS/DID card on EHWIC port free on the Cisco 2911 router
04-27-2016 11:42 PM
Hi Vijay,
As per documentation the Cisco 2900 and 3900 Series Integrated Services Routers support Network Modules and EVM Modules via an adapter (part number SM-NM-ADPTR). So i would assume it is required but i haven't checked it in the lab so can't verify it, maybe the Cisco TAC hardware team can confirm this.
Manish
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide