gateway and css

[susim]

Hi 

One single  router and single isdn line , now added one more router and another isdn line  

created a css named ' gateway_secondary ' and a partition created ' gateway_secondary ' and the partition added to the css  .

There are phones which is under partition called 'Primary_Partition ' 

I have added this 'Primary_Partition ' to the css  gateway_secondary .

created new DN and  assigned partition 'Primary_Partition '.But i cant dial this number from outside 

Thanks 

[Manish Gogna]

If the CSS for inbound calls on the gateway contains the partition of the IP phones to which you are trying to route the call, then it should be fine. The issue could be something else, like the number of significant digits ( called number ) that is being sent to the cucm. Make sure it is the same as the DN on the IP phone. You can check it by running a 'debug isdn q931' on the gateway and accordingly adjust the significant digits setting on the gateway page on cucm. If the issue still persists, get a 'debug isdn q931' output for a failed call to begin with. Also, depending on the gateway protocol please ensure that the correct dial-peer is in place in case its a new range of DID.

HTH

Manish