Gateway - Gatekeeper registration issue

[AlanJamesNet5]

Hey All,

I'm having some issues with registering a gateway to a gatekeeper.

I did a "debug debug h225 asn1 " on the the gatekeeper, i saw the request messages being received. But I didn't see any reject messages.

Once thing I did notice on the gatekeeper if i did a

debug ras

I get the below message

Jan 17 09:45:59.465:  IPSOCK_RAS_sendto:   msg length 45 from 192.168.254.40:1719 to 192.168.173.1: 55861

192.168.254.40 is a loopback address on the gatekeeper, my gateway is trying to register to 192.168.254.5 as below.

h323-gateway voip id KEST_CHPP_GK1 ipaddr 192.168.254.5 1718

Should the reply from my gatekeeper RAS be from 192.168.254.5?

Any suggestions how i can further trouble shoot the end point registration if there are no reject messages ?

Many Thanks

[DaveX4285_2]

Can you post the relevant Configuration from the gatekeeper. Possibly the h323 gateway?

[AlanJamesNet5]

Hey there, thanks for the reply

I've just pasted the config relevant to the site, we have another gatekeeper that works fine with this configuration, but i'm migrating to a new router 3945 - 15.1(4)M2, and the end points wont register to this new gatekeeper.

interface GigabitEthernet0/0.20

description *** VOIP ***

encapsulation dot1Q 20

ip address 192.168.173.1 255.255.255.192

h323-gateway voip interface

h323-gateway voip id KEST_CHPP_GK1 ipaddr 192.168.254.5 1718

h323-gateway voip h323-id KEST_CHPP_CCME@TEST.com.au

h323-gateway voip tech-prefix 1#

h323-gateway voip bind srcaddr 192.168.173.1

end

gatekeeper

zone local KEST_CHPP_GK1 TEST.com.au

bandwidth total zone KEST_CHPP_GK1 128

gw-type-prefix 1#* default-technology

arq reject-unknown-prefix

zone prefix KEST_CHPP_GK1 226.

no shutdown

SR_3945#show gatekeeper status

    Gatekeeper State: UP

    Zone Name:        KEST_CHPP_GK1

Alan

[AlanJamesNet5]

ok i think my orginally direction was correct

the output from the orginal debug ras command

Jan 17 09:45:59.465:  IPSOCK_RAS_sendto:   msg length 45 from 192.168.254.40:1719 to 192.168.173.1: 55861

(192.168.254.40 is the loop back of the router)

I changed the following on the gatekeeper

zone local KEST_CHPP_GK1 test.com.au 192.168.254.5 (specified the ras address)

new debug ras

Jan 18 00:41:40.573:  IPSOCK_RAS_sendto:   msg length 82 from 192.168.254.5:1719 to 192.168.173.1: 55861

So, my question is how to define the ras address globally ? As I have not done this on the other gatekeeper.

Thanks again,

Alan