cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1143
Views
0
Helpful
5
Replies

Get config off VG248

burleyman
Level 8
Level 8

How can I get the config off a VG248?

Mike

2 Accepted Solutions

Accepted Solutions

Here are the steps to take backup and restore the config on VG 248.

1. From the Command Line Interface (CLI), issue the *ftp* command to

connect to the VG248.

2. Hit *Enter* in username field.

3. If the Telnet password is configured, enter it in the password

field for FTP, otherwise leave it blank.

4. Issue the *dir* commnad to view the files.

5. Issue the *get *command and the respective file name (for example,

issue *get user.cfg*) to copy the file for user.cfg.

6. When the transfer completes, this file is copied to the PC.

The files are stored in recent folders under Documents and

Settings in windows. *Note:* Also, there is a user.cfg.xml file

that you can backup for port config.

Thanks,

Naveen

please rate helpful posts

View solution in original post

Please go to start > Run. type in cmd, and then follow the steps as suggested from the previous post.

You need to FTP into the device inorder to collect the configuration information. A "?" will give you the list of options on what you want ot "get" from the VG248.

Thanks,

Naveen

View solution in original post

5 Replies 5

Here are the steps to take backup and restore the config on VG 248.

1. From the Command Line Interface (CLI), issue the *ftp* command to

connect to the VG248.

2. Hit *Enter* in username field.

3. If the Telnet password is configured, enter it in the password

field for FTP, otherwise leave it blank.

4. Issue the *dir* commnad to view the files.

5. Issue the *get *command and the respective file name (for example,

issue *get user.cfg*) to copy the file for user.cfg.

6. When the transfer completes, this file is copied to the PC.

The files are stored in recent folders under Documents and

Settings in windows. *Note:* Also, there is a user.cfg.xml file

that you can backup for port config.

Thanks,

Naveen

please rate helpful posts

When I telnet into the VG248 it comes up with a menu not CLI. The menu has Config, Display, Diagnostics

Is there a special way to get to the CLI?

Mike

Please go to start > Run. type in cmd, and then follow the steps as suggested from the previous post.

You need to FTP into the device inorder to collect the configuration information. A "?" will give you the list of options on what you want ot "get" from the VG248.

Thanks,

Naveen

Got you....sorry it has been a very bad day.

Thank you.

Mike

You're welcome. Hope you have a nice day tomorrow.

Naveen

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: