I have CUCM 7.1.5 and many gateways connected with it ( Central Call processing model). Gateways are connected with CUCM using h323 protocol. I came to know that CUCM uses "+" in order to achieve globalization and normalization (E.164).
My question is that what is Globalization and Normalization? What does it do? IS it helpful in above setup? If so, then how can i configure this?
I would suggest you start out by reading the dial plan section of CUCM SRND, I would recommend reading the latest release for version 9, as it does a really good job of covering it, you can locate the SRNDs for CUCM here:
There are cases/situations where we have to configure custome CPTONE to resolve FXO disconnect issue. Following are situations which can arise due to FXO disconnect issue:
Phone A calls Phone B, Phone B does not answer. Phone A then goes on-hook but Phon...
Cisco announced major enhancements today to Webex Contact Center. Learn more about the highlights including
better support for the needs of large contact centers worldwide
improvements in the agent and cust...
SymptomsI’m doing a factory reset on the mobile board and it’s giving me the same issues that I wasn’t able to also send over last time. It says that it can’t connect to the server because of a firewall (we don’t have one) and then sometimes it...