cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

472
Views
0
Helpful
3
Replies
Highlighted
Beginner

Hardware conferencing on 2921 router

Hi,

I have configured hardware conferencing on 2921 router, however, it is not getting registered with CUCM version 8.5, I wanted to ask is it mandatory to configure router as MGCP or H.323, is it mandatory to have E1 termination and register the router with CUCM prior to configure conferencing.

Rgds.....Navinder.

3 REPLIES 3
Highlighted
Beginner

Hardware conferencing on 2921 router

No, it is not necessary to use the Router for anything else. You can setup the router to work only as MTP/XCODE/CFB. To look into why it is not registering, a few things to check would be to ensure that you have the sccp profile configured and associated it with the ccm and using the same name on CUCM.

Highlighted
Collaborator

Re: Hardware conferencing on 2921 router

Hello Navinder,

No the H.323 and MGCP are call signaling protocols.

For Hardware CFB, you need resources on your gateway, and apply the correctly configurations on your CUCM and Voice gateway

Take a look on this guides:

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_configuration_example09186a0080334294.shtml

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/8_6_1/ccmsys/a05confb.html#wpxref27448

Regards

Leonardo Santana

Rate this if helps!

Highlighted
Hall of Fame Master

Hardware conferencing on 2921 router

Can you post your config and a screen shot of the conference bridge configuration in CUCM?

Chris

CreatePlease to create content
Content for Community-Ad
Future of Work Virtual Summit Day 5

Cisco COVID-19 Survey