Hide CMC code

[amarabdelwahab]

    I just implement CMC code to restrict users being making calls without enter the CMC code. But I faced problem that when the users prompted to enter the code or password, the code appears so anybody can see it. Does anybody know how to make that password invisible to others?

Best Regards,

[Mohammed Khan]

CMC is not considered as secure, hence this is working as design.Try using FAC instead.

[Ritesh Desai]

Hey folks,

Am implementing PCCE v11.0.1 solution in INTERNATIONAL BPO. International PRI's is terminated on gateway. Am configuring FAC on CUCM v11.0.1 and somehow FAC code is displayed on IP Communicator. Calls donot route but if FAC is removed calls pass through Gateway successfully. I've worked earlier on v10 versions.

Made sure about following things...

1. FAC code config
2. FAC applied to route pattern.
3. Partition applied to Route Pattern.
4. Same partition applied to correct phone (CIPC).
5. Correct dial-peer with forward-all digits.
6. While debbuging on VG, calling number does not show.

Is there am missing any, please suggest.

As far am aware NO SPECIFIC FAC codes are required for International PRI's.

Thanks & regards,

Ritesh Desai.

[Ritesh Desai]

hey team,

Any luck... I tried replacing to different CIPC v8.6.4.3 ES patch, though bad luck. Earlier I was using CIPC v8.6.1.

regards,

Ritesh Desai.

[Ritesh Desai]

hey folks,

Found the root cause for this. SIP doesnot hide the FAC. SCCP hides the FAC code.

regards,

Ritesh Desai.