cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
953
Views
0
Helpful
4
Replies

Hold music stopped working for inbound calls

We have UCM 10.5, MOH stopped working for inbound calls where it works for outbound calls.

All the media resources and MOH configurations looks ok

4 Replies 4

Vaijanath Sonvane
VIP Alumni
VIP Alumni

Hi

Please answer below questions:

1. What the gateway model and IOS version?

2. Are you using SIP Trunk or PRI lines? please post you gateway configuration.

3. Do you have gateway device pool configured with MRGL?

4. Which codec you are using between Phone device pool and gateway device pool?

Ensure that the region between the MOH server and the GW is G711 if you want it to play as G711, otherwise you need to enable G729 codec under MOH service parameters. Try adding software MTP resource under MRGL and enable MTP on SIP Trunk.

 

Please rate helpful posts and if applicable mark "Accept as a Solution".
Thanks, Vaijanath S.

1. What the gateway model and IOS version?
Cisco 3945 ISR , 15.4(3)M8
2. Are you using SIP Trunk or PRI lines? please post you gateway configuration.
PRI lines, we have other gateways ISR 4451 with SIP trunk MOH on 4451 VG works fine
3. Do you have gateway device pool configured with MRGL?
Yes
4. Which codec you are using between Phone device pool and gateway device pool?
G.722, G.711

HARIS_HUSSAIN
VIP Alumni
VIP Alumni
Is the Path used for inbound and outbound calls the same ?

*** Please rate helpful post; Mark "Accept as a Solution" if applicable

Thanks,
Haris

Yes path is same we also tried restarting Cisco IP Voice Media Streaming App service on each CUCM server issue still not resolved

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: