Hotline configuration with Analog Phone on CME

[abdulkarim041]

Hi,

Can we configure Hotline feature on CME for analog phone?

phone B get a ring whenever phone A goes off hook?

BR

AbdulKarim

[George Sotiropoulos]

Please check the following post:

https://community.cisco.com/t5/ip-telephony-and-phones/hotline-configuration-with-ip-phone-on-cme/td-p/2591689

Kind regards,

George

[abdulkarim041]

thank you so much.

your mentioned link is for IP phones not analog phones with CME.

I need Hotline feature for analog phones with CME.

BR
abdul Karim

[Prassha]

Hello Abdul
Can you share the CME/IOS version for your router?
Let me know if the analog device connected through FXS or by an ATA device.
You can enable " Trunk destination on analog port". This feature is also IOS dependent in case of CME.

Regards,
PRASSHA3

Rate if you find this helpful or Mark Solutions as Accepted

[rasevedo65]

can this be done on a VG350? if so will it be a statement written in the configuration.