01-13-2014 12:51 AM - edited 03-16-2019 09:12 PM
Hello Community.
This is my SIP Phone config:
voice register dn 2
number 214
name xxx
no-reg
label xxx
voice register pool 2
id mac 44E4.D944.9B11
session-transport tcp
type 9971
number 1 dn 2
number 2 dn 3
dtmf-relay rtp-nte
username xxx password xxx
codec g711ulaw
And this is the SCCP Phone:
ephone 12
device-security-mode none
mac-address 0011.2014.8248
ephone-template 16
username xxx password xxx
type 7960 addon 1 7914
button 1:12 2:51 8m11 9m10
button 10m15 11m13 12m16 13m17
button 14m18
Hope you can help, thanks Patrick
Solved! Go to Solution.
01-13-2014 12:57 AM
Yes you can.
Sample config :
sip-ua
presence enable
!
presence
presence call-list
max-subscription 64
watcher all
allow subscribe
!
ephone-dn 12
number 2010
allow watch
blf-speed-dial 1 214 label "Teset-User"
!
voice register dn 2
number 214
allow watch
CME admin guide:
http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmepres.html#wp1011193
Please rate replies and mark question as "answered" if applicable.
01-13-2014 12:57 AM
Yes you can.
Sample config :
sip-ua
presence enable
!
presence
presence call-list
max-subscription 64
watcher all
allow subscribe
!
ephone-dn 12
number 2010
allow watch
blf-speed-dial 1 214 label "Teset-User"
!
voice register dn 2
number 214
allow watch
CME admin guide:
http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmepres.html#wp1011193
Please rate replies and mark question as "answered" if applicable.
01-13-2014 02:10 AM
Hi and thanks for the answer.
The command "blf-speed-dial 1 214 label "Test-User" is recongnized under the command "ephone-dn" but it works under the command "ephone".
Best regards patrick
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: